Step 7: Wipe Down the Vacuum’s Exterior.
Use a small pair of scissors to cut away hair that’s become tangled around the brush bar.There is a groove along one side of the brush which you can run your scissors along.
Once the hair has been cut, pull it away from the brush by hand.. (Optional) Wipe away dirt and grime with a damp cloth.If you want to give the brush a more thorough clean, use a damp, soft cloth to wipe away dirt (avoid cleaning products or detergents – just use plain water).Make sure that the brush is completely dry before re-inserting it into the vacuum though, otherwise more dirt will instantly stick to it.. Re-insert the brush bar into the vacuum.. You’ll need to insert the end of the brush opposite the side with the button first.
Once that end has been inserted, gently push the brush until you hear a satisfying click..Remember to replace the battery!.
Keep in mind that the red lights indicating a blockage won’t switch off straight away.
It’ll take around 10 seconds for the lights to go out and the vacuum to restart after the jam has been resolved.. Related Article:.Shark vacuums often have headlights for illuminating dust and dirt.
However, these may flash if there is an issue with the brush roll..In most cases, flashing headlights are due to the brush roll not being replaced correctly after cleaning.
Make sure that both sides of the floorhead lid are correctly locked into position to prevent this error..Frequently Asked Questions.